This is a module that can receive 10 channels of various signals such as pressure, temperature, and flow rate and transmit them to PLC or MMI.

Feature

-TC/mA Type Sensor 10Channel Signal

-Processed with a high-performance, high-precision 16-bit A/D converter and transmitting the measured values ​​to ModBus RTU.

Sensor Calibration

If the zero point changes due to using the sensor for a long time or if an error occurs due to the long sensor line length,

Ability to add or subtract correction values

Before sensor correction = 510℃

After sensor correction = measured value + correction value 

                             510℃ - 10℃ = 500℃

Display Scaling

If the input is mV, the input value can be displayed by scaling.

Example) Input is 0~100mV Display 0.0~800.0

    IN-H = 100.0 / IN-L = 0.0       SC-H = 800.0 / SC-L = 0.0

Installation Precautions

-Do not tighten the mounting bolts too much.

-Cannot be used at altitudes above 2000M. 

-Be sure to install indoors or in a non-exposed location. 

-Please avoid the installation locations below. 

 Places with corrosive gases, places with heavy dust, places with strong high frequencies, places with moisture, places subject to vibration or heat. 

Need help?

Contact an Applicarions specalist by sending an email to KVC or Call 032-234-3030

Specification

-INPUT : TC/mV 10CH

-Measurement and update cycle :200ms/10CH

-Accuracy : ±0.2%FS

-CMRR(Common Mode Rejection Ratio) : 140db or more

-NMRR(Normal Mode Rejection Ratio) : 50db or more

-Built-in moving average filter

-ModBus communication output (Option)

 Method: RS485 

 data length: 8bit 

 Speed: 4800, 9600, 19200, 38400, 15200 (standard 38400) 

 Parity : Even Parity

 Maximum number of connected units: 32

 Protocol : ModBus 1.1 RTU

 Insulation Resistance : 100MΩ/1000VDC

-Terms of use 

 Operating temperature and humidity: -5℃~55℃, 10℃~90℃ 

 Storage temperature and humidity: -20℃~70℃, 5℃~95℃ 

-Power voltage 

 Voltage used: DC12~30Volt (within 200mA) 

 Power consumption: 5W (MAX) 

 Insulation resistance: 100mΩ, INPUT(power)-RS485 MoBus 

-etc

 Weight: 500g 

 Mounting method: Rail mounting type